This is an old revision of the document!
Table of Contents
Step by Step ir-serial mit ir-keytable
Liste der devices anzeigen
BVDR> ir-keytable
Found /sys/class/rc/rc0/ (/dev/input/event14) with:
Driver cx88xx, table rc-tevii-nec
Supported protocols: lirc
Enabled protocols: lirc
Name: cx88 IR (TeVii S464 DVB-S/S2)
bus: 1, vendor/product: d464:9022, version: 0x0001
Repeat delay = 500 ms, repeat period = 125 ms
hier sieht man nur das device der DVB Karte - dieses soll allerdings nicht genutzt werden.
device anlegen
Da serial nicht automatisch erkannt werden kann muss es manuel getriggert werden:
festlegen an welchem COM Port es angeschloßen ist(hier com1)
setserial /dev/ttyS0 uart none
nun die Treiber laden:
modprobe serial-ir
dmesg sagt nun:
[ 3689.460620] serial_ir serial_ir.0: auto-detected active low receiver
[ 3689.483767] Registered IR keymap rc-rc6-mce
[ 3689.484744] IR RC6 protocol handler initialized
[ 3689.506815] rc rc1: Serial IR type home-brew as /devices/platform/serial_ir.0/rc/rc1
[ 3689.506875] input: Serial IR type home-brew as /devices/platform/serial_ir.0/rc/rc1/input18
[ 3689.507978] ir-keytable[3573]
[ 3689.516070] rc rc1: lirc_dev: driver serial_ir registered at minor = 1